Boba Bliss
We've compiled all our instructional content in one tidy place so you can comfortably enjoy every second of your babywearing journey!
Healthy Hip Positioning
We care about the safety and ergonomics of your babywearing adventure and those little developing hips, so make sure your baby is always supported from knee to knee and all across their back with knees at hip level or higher! Learn more at our "What's a Pelvic Tuck?" blog post!
Complimentary Fit Consultations
Still can't quite figure it out or just want to confirm that your baby is ergonomically positioned and comfortable? We want you to have the best, safest, most comfortable, and magical experience wearing your little one! Schedule your complimentary one-on-one video call with our babywearing educator!
Read & Learn
Whether this is your first time babywearing or you live with a baby strapped to you, we guarantee you'll find tons of helpful information over at our blog! Plus in-depth research on the science behind babywearing and then some at our "Boba Reads" blog section!
This will be amazingly snug and comfortable but remember — it’s a new experience for you and your baby!
Make sure that baby is well-fed and not overtired when you first start using the carrier.
Try practicing in front of the mirror.
If baby starts getting fussy, just take a deep breath and a few steps around the room until you’re both ready to continue.
Once positioned correctly, your baby should be snug against your body, high on your chest, enabling you to stand normally, as if you were holding them in your arms.
Book a free fit consultation for personalized one-on-one support from the comfort of your home!
How to wear
Ultimate comfort, no tying required!
STEP 1: Snap the soft modular waistband around your natural waist (or higher if needed for smaller babies)
STEP 2: Position baby on your front and bring the panel of the carrier over their back
STEP 3: Bring one shoulder strap over the opposite shoulder, buckle the side buckle, and tighten as needed. Repeat on the other side!
How your baby is adapted to being carried
The Boba Bliss is designed for wearing babies in the inward-facing front carry to reap all the benefits of that "heart to heart position."
Not only does it keep your sweet load close to your center of gravity,
the stretchy panel also allows baby to spontaneously sink their bum below the waist-belt and assume the natural ergonomic spread squat position, which helps them actively contribute to being carried!
Checklist for comfortable & ergonomic babywearing
A. baby’s face is close enough to kiss and in view at all times
B. baby’s nose is parallel to the ground or higher
C. baby’s spine, pelvis, and legs are well supported
D. baby’s spine forms a gentle “J” shaped curve
E. baby’s legs are in a spread-squat position & supported knee-to-knee
Ergonomic positioning matters (especially in those first 6 months)!
Small infants have gently curved spines, and their natural ergonomic position is with their knees drawn up into a comfortable “M shape”/frog position/spread squat.
From this wide seat base, babies can be properly supported all the way up to the back of the neck, and their weight is equally distributed, thus preventing the babies from slumping in the carrier (or if they are being carried in arms).
To ensure your baby is in an optimal ergonomic position, you can hold your baby’s legs under their knee pits and gently scoop them towards your body in an upwards motion, rotating and tucking their pelvis under. This helps create a “J shape” (from the side) or an “M shape” (from the front) position!
This ergonomic positioning also helps encourage healthy hip development and prevent hip dysplasia!
Breastfeeding in the Boba Bliss
Fitting your carrier for nursing and redistributing the slack when you're done has never been easier!
STEP 1: Loosen the waistband buckle and release the breastfeeding access buckles to get some slack
STEP 2: Scoot baby down.
STEP 3: Hold your breast and latch!
Once your baby is done nursing, scoot them back up and re-tighten straps as needed.
Learn more tricks for simple and convenient feeding in the carrier!
X straps that fit to a T!
The wrap-like shoulder straps are adjustable in both length and width to ensure a perfect fit for all wearers!
Spread the fabric wide over your shoulders and back for ideal weight distribution and to help keep your sweet load close to your center of gravity.
Adjusting the shoulder straps nice and snug is easiest when tightening one strap at a time!
Make sure to pass the safety elastic loop on the side buckle padding!
Head support for a blissfully sleeping baby!
Always make sure your baby’s face is unobstructed by any fabric and that their nose and mouth are at least parallel with the floor or pointing up.
Ticking all the boxes for a safe and secure carry is pretty easy in the Boba Bliss.
The crossed layers of fabric work as excellent head support from birth, and you can regulate the height of the panel and coverage (or lack thereof) just by sliding the loops on your shoulder straps up or down!
These functional accessories conveniently enable a great view of and for your baby and secure head coverage for contact naps!
No twisting or flipping of the fabric needed!
